Foxboro IPM2-P0904HA - I/A Series Intelligent HART Positioner Module

Foxboro IPM2-P0904HA – I/A Series Intelligent HART Positioner Module

In stock

Product Introduction:
The Foxboro IPM2-P0904HA is an intelligent positioner module for the Foxboro I/A Series Distributed Control System. The “IPM” stands for Intelligent Positioner Module, “2” indicates the second generation of the module, “P0904” identifies the specific configuration (4-20mA input with HART), and “HA” denotes the HART-compatible revision. This module accepts 4-20mA signals from HART-enabled field transmitters and positioners while simultaneously supporting HART digital communication for configuring and diagnosing the field devices remotely. The IPM2 is used in applications where both the analog process variable and the digital diagnostics from the transmitter are required for control decisions. The HART protocol allows operators to read secondary variables (like temperature, pressure, and diagnostics) from the same 4-20mA loop used for the primary control signal.

Technical Specifications:
Board Type: Intelligent Positioner Module with HART
System: Foxboro I/A Series (Series 400)
Channels: 4 independent input channels (configurable as 4 AI or 2 AI + 2 AO)
Input Signal: 4-20mA, 2-wire HART 7 compliant
Resolution: 16-bit A/D conversion
Accuracy: +/- 0.1% of full scale
HART Protocol: HART 7 (1200 baud FSK), supports burst mode and continuous mode
Isolation: 1500V RMS channel-to-channel and channel-to-ground
Update Rate: 250 milliseconds per channel (HART polling)
Diagnostics: HART device diagnostics (burst mode, continuous mode, automatic mode)
Power: 24V DC from I/A backplane
Form Factor: 3U I/A Series Eurocard
Operating Temperature: 0 to 60 degrees Celsius

Functional Features:
HART Communication: Supports all standard HART commands for reading primary and secondary variables, device status, and diagnostics.
Simultaneous Analog and Digital: Reads the 4-20mA control signal and HART digital data at the same time.
Per-Channel Configuration: Each channel independently configurable for input range, filtering, and HART polling mode.
Burnout Detection: Automatically detects open transmitter wires (burnout) and alarms the processor.
Self-Diagnostics: Continuous self-test of A/D converters, HART modem, and isolation barriers.
Fail-Safe Output: On communication loss, the module drives the processor input to a predetermined safe value (typically 3.6mA or 21mA).
LED Indicators: Per-channel LEDs show input status and HART communication activity.

Application Scenarios:
Process Control: Reads HART-enabled pressure transmitters and temperature transmitters for closed-loop control.
Remote Diagnostics: Allows maintenance engineers to read transmitter diagnostics (sensor health, impulse line blockage) from the control room via HART.
Valve Positioning: Controls smart positioners on control valves using HART communication for precise positioning.
Calibration Verification: Uses HART to verify transmitter calibration without physically accessing the field device.

Show More Show Less